HP CM8060 Color MFP Kundendienst Handbuch Seite 1340

A2.02C2: Elevator does not go all the way to the bottom
Initial Steps
1. If the power is removed from the system and there is more than one ream of paper in the tray, the elevator tray could drift all the way
to the bottom of the elevator travel. This is normal behavior. There is no brake to stop the elevator.
HINWEIS: Set DVM to the appropriate range for the voltage.
„Tray 5 component locator" auf Seite 2363
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Test the Tray 5 Load Media sensor (SN109)
1. Manually activate SN109.
„Tray 5 component locator" auf Seite 2363
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
Test theTray 5 Media Door Open sensor (SN107)
1. Manually activate SN107.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
1 Does the sensor state change?
1 No Yes
1 2 „Final activities" auf Seite 24
1 „A2.02E4: Close Tray 5 top door" auf Seite 1284
Check the following conditions
1. Make sure that the sensor is correctly located.
2. Clean the sensor and the surrounding area.
3. If the sensor has a flag actuator, check that the flag actuator has free movement.
4. Check the wire harness between the Tray 5 Media Door Open sensor (SN107) and the Motion PCA (A2).
„Tray 5 wiring diagram" auf Seite 2281
Test the Tray 5 Load Media sensor (SN109)
1. Manually activate SN109.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
1 „Final activities" auf Seite 24
1274 Kapitel 8 Hardware fault trees DEWW