HP CM8060 Color MFP Kundendienst Handbuch Seite 1262

A0.1301: No pick Tray 1
Initial Steps
1. Verify that the Tray 1 door is closed and latched.
Check the condition of the paper used in Tray 1.
Verify that the paper meets product specifications.
Verify that the paper loaded in Tray 1 has the paper curl facing up.
Verify that the paper is correctly loaded.
Verify that the paper-width guide touches the edge of the paper stack.
Verify that the customer has not overfilled the paper tray.
Ensure the wiring to the Tray 1 Media sensor (SN27) is not blocking the SN27 actuator. If so install print engine (PE) tag 3.
„Tray 1 component locator" auf Seite 2355
Test the Tray 1 Pick solenoid (SOL1)
1. Activate SOL1.
TIPP: Click Subsystems, click Input Trays, and then click Tray 1.
Does the solenoid activate?
No Yes
Cycle the Tray 1 Pick solenoid (SOL1)
1. Open the Tray 1 door, and then cycle SOL1.
2. Look and listen for the solenoid to cycle at a consistent rate.
ACHTUNG:
Before closing the Tray 1 door, verify that the Tray 1 pick roller is in the pick (home) position. Damage to SOL1 can occur
when the Tray 1 door is closed and the pick roller is not in the pick (home) position.
TIPP: Click Subsystems, click Input Trays, and then click Tray 1.
1 Does SOL1 cycle with a consistent rhythm?
1 No Yes
Check the following conditions
1. Verify that the pick roller rotates when the Tray 1 Pick solenoid (SOL1) activates.
2. Check the wire harness between the solenoid and the Motion PCA (A2).
„Tray 1 wiring diagram" auf Seite 2259
1 2 3. Check SOL1 for contamination.
Replace the Tray 1 Pick solenoid (SOL1)
1. Replace the solenoid.
1
„Tray 1 Pick solenoid (SOL1)" auf Seite 354
1196 Kapitel 8 Hardware fault trees
To safely activate SOL1, the Tray 1 door must be open and the vertical drive must be off.
DEWW