HP CM8060 Color MFP Kundendienst Handbuch Seite 1267

A1.0103: Tray 3 Pick motor (M20) stall
Initial Steps
1. Check the condition of the paper in the tray.
2. Verify that the paper guides are set correctly.
3. Verify that the right-side lower panel is latched.
4. Verify that the paper meets product specifications.
5. Verify that the paper-length guide functions correctly.
6. Check the preventive maintenance list for pick roller replacement.
7. If maintenance is due, replace the Tray 3 pick roller.
„Einzugswalze" auf Seite 332
8. Check the pick roller mounting locations for damage.
Check the 24 Vdc and 32 Vdc LEDs on the Trays 2, 3, and 4 Controller PCA (A23)
1. Verify that the LEDs are lit.
„Trays 2, 3, and 4 controller PCA diagram" auf Seite 2298
Are the 24 Vdc and 32 Vdc LEDs on A23 lit?
No Yes
Turn on the Tray 3 Pick motor (M20)
1. Pull out Tray 3.
2. Turn on M20.
ACHTUNG:
Do not turn on M20 with paper in the tray without having the paper transport running. Possible damage could be done to the
pick arm assembly.
TIPP: Click Subsystems, click Input Trays, and then click Trays 2, 3, 4.
1 Does M20 turn on?
1 No Yes
Check the pick arm conditions
1. Verify that the pick arm moves up and down freely.
2. Check the pick arm alignment. There might be a misaligned pin on the back of the tray.
1 2
Does the pick arm move freely?
1 2 No
1 2 3
Align the Tray 3 pick arm assembly
1 2 1. Align the Tray 3 pick arm assembly.
DEWW
Running the motor before pulling out the tray can damage the pick arm.
Yes
„Final activities" auf Seite 24
A1.0103: Tray 3 Pick motor (M20) stall 1201