HP CM8060 Color MFP Kundendienst Handbuch Seite 1350

A2.02E4: Close Tray 5 top door
Initial Steps
1. „Tray 5 component locator" auf Seite 2363
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Careful working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use frame as ground.
Test the Tray 5 Media Door Open sensor (SN107)
1. Manually actuate SN107.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
Test the Tray 5 top door
1. Manually open and close the Tray 5 top door. Look and listen for the latching mechanism to work.
2. Check the alignment between the door actuator and the sensor.
„Tray 5 component locator" auf Seite 2363
1 Does the Tray 5 top door latch function correctly?
1 No Yes
1 2 „Final activities" auf Seite 24
Check the Tray 5 top door
1. Visually check the Tray 5 top door latch, sensor actuator, and hinge mechanisms. Verify that they are making contact with the
1 Tray 5 Media Door Open sensor (SN107). Replace the door if necessary.
Check the following
1. Make sure that the sensor is correctly located.
2. Clean the sensor and the surrounding area.
3. Check that any flag actuator has free movement.
4. Check the wire harness between the Tray 5 Media Door Open sensor (SN107)and the Motion PCA (A2).
„Tray 5 wiring diagram" auf Seite 2281
Test the Tray 5 Media Door Open sensor (SN107)
1. Manually actuate SN107.
„Tray 5 component locator" auf Seite 2363
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
1 „Final activities" auf Seite 24
1284 Kapitel 8 Hardware fault trees DEWW