HP CM8060 Color MFP Kundendienst Handbuch Seite 1445

B2.1304: Paper jam at IDO Input Media sensor (SN8)
Initial Steps
1. Check for obstructions in the paper path.
2. Check the condition of the paper.
„IDO component locator" auf Seite 2365
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
3. Check the sensor for excessive paper dust.
Test the IDO Input Media sensor (SN8)
1. Manually activate SN8.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
1 „B2.0103: IDO Curler motor (M15) stall" auf Seite 1340
Check the following
1. Verify that the sensor is correctly located.
2. Verify that all of the idler rollers are correctly seated and that the drive roller surfaces are free of defects.
3. Clean the sensor and the surrounding area.
4. If the sensor has a flag actuator, check that the flag actuator has free movement.
5. Check the wire harness between the IDO Input Media sensor (SN8) and the Motion PCA (A2).
„IDO paper path 1 wiring diagram" auf Seite 2285
Test the IDO Input Media sensor (SN8)
1. Manually activate SN8.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
„Final activities" auf Seite 24
1
DEWW B2.1304: Paper jam at IDO Input Media sensor (SN8) 1379