HP CM8060 Color MFP Kundendienst Handbuch Seite 1359

A2.06C2: Tray 5 Top-left Panel LED (LED101) not lit
Initial Steps
1. „Trays 2, 3, and 4 component locator" auf Seite 2370
Test the Tray 5 Top-left Panel LED (LED101)
1. Activate LED101.
2. Check to see if the LED turns on and off.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the LED turn on and off?
No Yes
Check for problems that might cause intermittent behavior
1. Check the wire harness between the Motion PCA (A2) and the LED.
„Tray 5 wiring diagram" auf Seite 2281
1 2. Check the LED mounting and surrounding area for any obvious problems. Repair as needed.
Inspect the Tray 5 Top-left Panel LED (LED101) and wire harness for bad conditions
1. Verify that the LED is correctly located.
„Tray 5 wiring diagram" auf Seite 2281
2. Check the wire harness between the Motion PCA (A2) and the LED.
Test the Tray 5 Top-left Panel LED (LED101)
1. Activate LED101.
2. Verify that the LED turns on and off.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the LED turn on and off?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the Tray 5 Top-left Panel LED (LED101) on the Motion PCA (A2)
1. Disconnect J13 from the Motion PCA (A2).
2. Test the voltage to the Tray 5 Top-left Panel LED (LED101) on A2: 5 Vdc on J13 at pins 21 to 14.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
No Yes
DEWW A2.06C2: Tray 5 Top-left Panel LED (LED101) not lit 1293