HP CM8060 Color MFP Kundendienst Handbuch Seite 1295

A1.02E4: Tray 2 low
Initial Steps
1. „Trays 2, 3, and 4 component locator" auf Seite 2370
Check the Tray 2 Low sensor (SN44)
1. Verify that the tray contains approximately ten sheets of paper.
2. Check SN44 for dust or paper debris. Clean as needed.
„Trays 2, 3, and 4 component locator" auf Seite 2370
3. Open and close the tray to toggle SN44 on the pick arm.
TIPP: Click Subsystems, click Input Trays, and then click Trays 2, 3, 4.
Does the sensor state change?
No Yes
Check for intermittent behavior
1. Place varying amounts of paper in the tray.
2. Open and close the tray to toggle the Tray 2 Low sensor (SN44) on the pick arm.
1 „Trays 2, 3, and 4 component locator" auf Seite 2370
Test another paper tray
1. Open a different tray.
2. Verify that the tray contains approximately ten sheets of paper.
3. Open and close the tray to toggle the tray paper low sensor on the pick arm.
TIPP: Click Subsystems, click Input Trays, and then click Trays 2, 3, 4.
Does the sensor state change?
No Yes
Switch the tray cables
1. On the Trays 2, 3, and 4 Controller PCA (A23), disconnect the Tray 3 cable from J7.
2. On A23, disconnect the Tray 2 cable from J6.
3. Connect the Tray 2 cable to J7 on A23.
4. Open and close Tray 2. Tray 2 is now detected as Tray 3.
TIPP: Click Subsystems, click Input Trays, and then click Trays 2, 3, 4.
1 Does the sensor state change?
1 No Yes
„A1.0701: Trays 2, 3, and 4 Controller PCA (A23) failure" auf Seite 1251
1 2
DEWW A1.02E4: Tray 2 low 1229