HP CM8060 Color MFP Kundendienst Handbuch Seite 1427

B2.03C1: IDO Diverter solenoid (SOL2)
Initial Steps
1. Check the solenoid for mechanical binding, contamination, excessive wear, and correct installation.
„IDO component locator" auf Seite 2365
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Test the IDO Diverter solenoid (SOL2)
1. Select and deselect SOL2.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the solenoid energize and de-energize?
No Yes
Service the solenoid
1. Check the solenoid for mechanical binding, contamination, excessive wear, and correct installation.
1
2. Adjust or repair as needed.
Check the following conditions
1. Check the solenoid for mechanical binding, contamination, excessive wear, and correct installation.
2. Check the wire harness between the IDO Diverter solenoid (SOL2) and the Motion PCA (A2).
„IDO paper path 1 wiring diagram" auf Seite 2285
Test IDO Diverter solenoid (SOL2)
1. Select and deselect SOL2.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the solenoid energize and de-energize?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the IDO Diverter solenoid (SOL2) on the Motion PCA (A2)
1. Disconnect J14 from A2.
2. Test the voltage to SOL2 on A2: 20 Vdc at J14 pins 6 to 15.
„Motion PCA (A2) diagram" auf Seite 2308
VORSICHT! Use an ESD strap.
Is the voltage correct?
No Yes
DEWW B2.03C1: IDO Diverter solenoid (SOL2) 1361