HP CM8060 Color MFP Kundendienst Handbuch Seite 1368

Test the voltage to the Vertical motor (M6) on the Motion PCA (A2)
1. Disconnect J2 from A2.
2. Test the voltage to M6 on A2: 12 Vdc at J2 pins 1 to 8.
„Motion PCA (A2) diagram" auf Seite 2308
TIPP:
1 2 Is the voltage correct?
1 2 No
1 2 3
1 2 3
1 2 3
1 2 3
Replace the Motion PCA (A2)
1. Replace A2.
1 2
„Motion PCA (A2)" auf Seite 710
Test the voltage at the Vertical Motor encoder (EN12)
1. Verify that J10 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from EN12.
3. Test the voltage at EN12: 5 Vdc at pins 3A to 1A (GND) on W14P6-W36J6.
„Vertical wiring diagram" auf Seite 2301
„Vertical component locator" auf Seite 2372
1 Is the voltage correct?
1 No Yes
1302 Kapitel 8 Hardware fault trees
Click Subsystems, click Paper Path, and then click Vertical Transport.
Yes
Test the voltage at the Vertical motor (M6)
1. Verify that J2 is connected to the Motion PCA (A2).
2. Disconnect the wire connector from the motor.
3. Test the voltage at M6: 12 Vdc at pins 1 to 2 on W20P6-M6.
„Vertical wiring diagram" auf Seite 2301
„Vertical component locator" auf Seite 2372
TIPP: Click Subsystems, click Paper Path, and then click Vertical Transport.
Is the voltage correct?
No Yes
Replace the Vertical motor (M6)
1. Replace M6.
4 „Vertical motor (M6)" auf Seite 387
Check the wire harness between the Motion PCA (A2) and the Vertical motor (M6)
1. Check the wire harness and connections between A2 and M6.
2. Repair as needed.
„Vertical wiring diagram" auf Seite 2301
DEWW