HP CM8060 Color MFP Kundendienst Handbuch Seite 1425

B2.0301: Able to open locked left-side upper panel
Initial Steps
1. Check the solenoid for mechanical binding, contamination, excessive wear, and correct installation.
„IDO component locator" auf Seite 2365
HINWEIS: Set the DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Test the IDO Interlock solenoid (SOL3))
1. Select and deselect SOL3.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the solenoid energize and de-energize?
No Yes
Service the IDO Interlock solenoid (SOL3)
1. Check the alignment of the solenoid to the latch.
2. Check the left-side upper panel alignment, handle, and hinge.
1 3. Adjust or repair as needed.
Check the following conditions
1. Check the wire harness between the IDO Interlock solenoid (SOL3) and the Motion PCA (A2).
„IDO H-bar wiring diagram" auf Seite 2287
Test the IDO Interlock solenoid (SOL3)
1. Select and deselect SOL3.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the solenoid energize and de-energize?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the IDO Interlock solenoid (SOL3) on the Motion PCA (A2)
1. Disconnect J14 from A2.
2. Test the voltage to SOL3 on A2: 20 Vdc at J14 pins 9 to 18.
„Motion PCA (A2) diagram" auf Seite 2308
VORSICHT! Use an ESD strap.
Is the voltage correct?
No Yes
DEWW B2.0301: Able to open locked left-side upper panel 1359