C4.0101: Web Drive Motor (M5) Stall - HP CM8060 Color MFP Kundendienst Handbuch

C4.0101: Web Drive motor (M5) stall

Initial Steps
1. „Web wipe component locator" auf Seite 2373
HINWEIS: If a servo motor is powered on, it feels like there is a bind.
Set DVM to the appropriate range for the voltage.
When testing the web drive motor remove the web wipe cartridge. Removing the web wipe cartridge saves web material.
VORSICHT! Be careful when working around electricity.
ACHTUNG: Do not use the frame as ground.
Check the web wipe cartridge installation
1. Verify that the web wipe cartridge is correctly installed.
Is the web wipe cartridge correctly installed and latched?
No Yes
Check the Web Drive Motor encoder (EN10) count
1. Remove the web wipe cartridge from the unit.
2. Turn the Web Drive motor (M5) by hand.
„Web wipe component locator" auf Seite 2373
TIPP: Click Subsystems, and then click Web Wipe.
1
Does the EN10 count change?
No Yes
1
Test the Web Drive motor (M5)
1. With the web wipe cartridge removed, turn on M5.
„Web wipe component locator" auf Seite 2373
TIPP:
1 2 Does the M5 turn in the forward direction?
No
1 2
1 2 3
1 2 3
DEWW
Click Subsystems, and then click Web Wipe.
Yes
Test the Web Drive motor (M5)
1. With the web wipe cartridge removed, turn on M5.
„Web wipe component locator" auf Seite 2373
TIPP: Click Subsystems, and then click Web Wipe.
Does the M5 turn in the reverse direction?
No Yes
C4.0101: Web Drive motor (M5) stall 1413