C2.06C1: Dryer Led (Led6) Not Lit - HP CM8060 Color MFP Kundendienst Handbuch

C2.06C1: Dryer LED (LED6) not lit

Initial Steps
1. „Dryer component locator" auf Seite 2359
Test the Dryer LED (LED6)
1. Activate LED6.
2. Verify that LED turns on and off.
TIPP: Click Subsystems, and then click Dryer.
Does the LED turn on and off?
No Yes
Check for problems that might cause intermittent behavior
1. Check the wire harness between the Motion PCA (A2) and the LED.
„Drum wiring diagram" auf Seite 2265
1 2. Check the LED mounting and surrounding area for any obvious problems. Repair as needed.
Check the LED and wire harness
1. Verify that the LED is correctly located.
„Drum wiring diagram" auf Seite 2265
2. Check the wire harness between the Motion PCA (A2) and the LED.
„Dryer wiring diagram" auf Seite 2267
Test the Dryer LED (LED6)
1. Activate LED6.
2. Verify that the LED turns on and off.
TIPP: Click Subsystems, and then click Dryer.
Does the LED turn on and off?
No Yes
1 „Final activities" auf Seite 24
Test the voltage to the Dryer LED (LED6) on the Motion PCA (A2)
1. Disconnect J8 from A2.
2. Test the voltage to LED6 on A2:0 vdc unblocked, 2.14 with the LED on at J8 pins 14A to 13A.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
No Yes
DEWW C2.06C1: Dryer LED (LED6) not lit 1405