HP CM8060 Color MFP Kundendienst Handbuch Seite 1407

Test the voltage to theIDO Curler motor (M15) on the Motion PCA (A2)
1. Test the voltage to M15 on A2: 17.75 Vdc at J14 pins 1 to 10.
„Motion PCA (A2) diagram" auf Seite 2308
TIPP:
1 2 Is the voltage correct?
No
1 2
1 2 3
1 2 3
1 2 3
1 2 3
Replace the Motion PCA (A2)
1. Replace A2.
1 2 „Motion PCA (A2)" auf Seite 710
Test the voltage to the IDO Curler Motor encoder (EN15) on the Motion PCA (A2)
1. Disconnect J5 from A2.
2. Test the voltage to EN15 on A2: 5 Vdc at J5 pins 3A to 1A.
„Motion PCA (A2) diagram" auf Seite 2308
1
Is the voltage correct?
No Yes
1
Test the voltage at the IDO Curler Motor encoder (EN15)
1. Verify that J5 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the encoder.
3. Test the voltage to EN15: 5 Vdc at pins 13A to 15A on W45P2-W87J2.
„IDO paper path 1 wiring diagram" auf Seite 2285
1 2 Is the voltage correct?
DEWW
Click Subsystems, click Paper Path, and then click IDO Motors.
Yes
Test the voltage at the IDO Curler motor (M15)
1. Verify that J14 is connected to the Motion PCA (A2).
2. Disconnect the wire connector from the motor.
3. Test the voltage at M15: 5.23 Vdc at pins 1 to 2 on W19P1-W86J1.
„IDO motors and encoders wiring diagram" auf Seite 2284
TIPP: Click Subsystems, click Paper Path, and then click IDO Motors.
Is the voltage correct?
No Yes
Replace theIDO Curler motor (M15)
4
1. Replace M15.
Check the wire harness
1. Check the wire harness between the Motion PCA (A2) and the IDO Curler motor (M15).
2. Repair as needed.
„IDO paper path 1 wiring diagram" auf Seite 2285
B2.0103: IDO Curler motor (M15) stall 1341