HP CM8060 Color MFP Kundendienst Handbuch Seite 1433

B2.06C2: Output Bin LED (LED14) not lit
Initial Steps
1. „IDO component locator" auf Seite 2365
Test the Output Bin LED (LED14)
1. Activate LED14.
2. Verify that the LED turns on and off.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the LED turn on and off?
No Yes
Check for problems that might cause intermittent behavior
1. Check the wire harness between the Motion PCA (A2) and the LED.
„IDO H-bar wiring diagram" auf Seite 2287
1 2. Visually check the LED mounting and surrounding area for any obvious problems. Repair as needed.
Check the LED and wire harness
1. Verify that the LED is correctly located.
„IDO component locator" auf Seite 2365
2. Check the wire harness between the Motion PCA (A2) and the LED.
„IDO H-bar wiring diagram" auf Seite 2287
Test the Output Bin LED (LED14)
IDO.LED.14 mode:
1. Activate LED14.
2. Verify that the LED turns on and off.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the LED turn on and off?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the Output Bin LED (LED14) on the Motion PCA (A2)
1. Disconnect J5 from A2.
2. Test the voltage to LED14 on A2: 4.9 Vdc at J5 pins 18A to 18B.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
No Yes
DEWW B2.06C2: Output Bin LED (LED14) not lit 1367