HP CM8060 Color MFP Kundendienst Handbuch Seite 1355

A2.02E6: Tray 5 empty
Initial Steps
1. Check the condition of the paper.
„Tray 5 component locator" auf Seite 2363
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Test the Tray 5 Empty sensor (SN111)
1. Manually activate SN111.
„Tray 5 wiring diagram" auf Seite 2281
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
„Final activities" auf Seite 24
1
Check the following conditions
1. Make sure that the sensor is correctly located.
2. Clean the sensor and the surrounding area.
3. Check the wire harness between the Tray 5 Empty sensor (SN111) and the Motion PCA (A2).
„Tray 5 wiring diagram" auf Seite 2281
Test the Tray 5 Empty sensor (SN111)
1. Manually activate SN111.
„Tray 5 wiring diagram" auf Seite 2281
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the Tray 5 Empty sensor (SN111) on the Tray 5 Distribution PCA (A101)
1. Disconnect J2 from A101.
2. Test the voltage to SN111 on A101: 4.93 Vdc unblocked and blocked at pins 6B to 4B and 0.01 vdc unblocked and 4.92 vdc blocked
at pins 5B to 4B on W102P102-A101J2.
„Tray 5 distribution PCA diagram" auf Seite 2282
VORSICHT! Use an ESD strap.
Is the voltage correct?
No Yes
DEWW A2.02E6: Tray 5 empty 1289