HP CM8060 Color MFP Kundendienst Handbuch Seite 1431

B2.06C1: Left-side Middle Panel LED (LED3) not lit
Initial Steps
1. „IDO component locator" auf Seite 2365
Test the Left-side Middle Panel LED (LED3)
1. Activate LED3.
2. Verify that the LED turns on and off.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the LED turn on and off?
No Yes
Check for problems that might cause intermittent behavior
1. Check the wire harness between the Motion PCA (A2) and the LED.
„IDO paper path 1 wiring diagram" auf Seite 2285
1 2. Visually check the LED mounting and surrounding area for any obvious problems. Repair as needed.
Check the Left-side Middle Panel LED (LED3) and wire harness
1. Verify that the LED is correctly located.
„IDO component locator" auf Seite 2365
2. Check the wire harness between the Motion PCA (A2) and the LED.
„IDO paper path 1 wiring diagram" auf Seite 2285
Test the Left-side Middle Panel LED (LED3)
1. Activate LED3.
2. Verify that the LED turns on and off.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the LED turn on and off?
No Yes
1 „Final activities" auf Seite 24
Test the voltage to the Left-side Middle Panel LED (LED3) on the Motion PCA (A2)
1. Disconnect J5 from A2.
2. Test the voltage on LED3 on A2:2.18 Vdc at J5 pins 9A to 10A.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
No Yes
DEWW B2.06C1: Left-side Middle Panel LED (LED3) not lit 1365