HP CM8060 Color MFP Kundendienst Handbuch Seite 1432

Test the voltage at the Left-side Middle Panel LED (LED3)
1. Verify that J5 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the LED.
3. Test the voltage at LED3: 2.17 Vdc at pins 7A to 6A on W96P6-W45J6.
1 Is the voltage correct?
No Yes
1
Replace the Left-side Middle Panel LED (LED3)
1. Replace LED3.
1 2 „IDO-LEDs" auf Seite 493
Check the wire harness between the Motion PCA (A2) and the Left-side Middle Panel LED (LED3)
1. Check the wire harness between A2 and the LED.
1 „IDO motors and encoders wiring diagram" auf Seite 2284
Replace the Motion PCA (A2)
1. Replace A2.
„Motion PCA (A2)" auf Seite 710
1366 Kapitel 8 Hardware fault trees DEWW