HP CM8060 Color MFP Kundendienst Handbuch Seite 1435

B2.06C3: IDO Curler LED (LED2) not lit
Initial Steps
1. „IDO component locator" auf Seite 2365
Test the IDO Curler LED (LED2)
1. Activate LED2.
2. Verify that the LED turns on and off.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the LED turn on and off?
No Yes
Check for problems that might cause intermittent behavior
1. Check the wire harness between the Motion PCA (A2) and the LED.
„IDO paper path 1 wiring diagram" auf Seite 2285
1 2. Visually check the LED mounting and surrounding area for any obvious problems. Repair as needed.
Check the IDO Curler LED (LED2) and wire harness
1. Verify that the LED is correctly located.
„IDO component locator" auf Seite 2365
2. Check the wire harness between the Motion PCA (A2) and the LED.
„IDO paper path 1 wiring diagram" auf Seite 2285
Test the IDO Curler LED (LED2)
1. Activate LED2.
2. Verify that the LED turns on and off.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the LED turn on and off?
No Yes
1 „Final activities" auf Seite 24
Test the voltage to the IDO Curler LED (LED2) on the Motion PCA (A2)
1. Disconnect J5 from A2.
2. Test the voltage to LED2 on A2: 2.17 Vdc at J5 pins 11A to 12A.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
No Yes
DEWW B2.06C3: IDO Curler LED (LED2) not lit 1369