HP CM8060 Color MFP Kundendienst Handbuch Seite 1420

No Yes
Test the voltage at the Left-side Lower Panel sensor (SN14)
1. Verify that J5 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the sensor.
3. Test the voltage at SN14: 3.20 Vdc blocked, 0.18 Vdc unblocked at pins 1 to 2 and 1.16 Vdc both unblocked and blocked at
pins 3 to 2 on W96J14-SN14.
„IDO H-bar wiring diagram" auf Seite 2287
1 Is the voltage correct?
No Yes
1
Replace the Left-side Lower Panel sensor (SN14)
1. Replace SN14.
1 2
„IDO-Sensoren" auf Seite 485
Check the wire harness
1. Check the wire harness and connections between the Left-side Lower Panel sensor (SN14) and the Motion PCA (A2).
„IDO H-bar wiring diagram" auf Seite 2287
1 2. Repair as needed.
„D4.0705: Motion PCA (A2) power not good" auf Seite 1469
1354 Kapitel 8 Hardware fault trees DEWW