HP CM8060 Color MFP Kundendienst Handbuch Seite 1406

B2.0103: IDO Curler motor (M15) stall
Initial Steps
1. „IDO component locator" auf Seite 2365
HINWEIS: If a servo motor is powered on, it will feel like there is a bind.
Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Turn the IDO Curler motor (M15) by hand
1. Turn M15 by hand with Tray 1 engaged. All of the rollers should turn.
„IDO component locator" auf Seite 2365
Do the rollers turn?
No Yes
Check the IDO Curler Motor encoder (EN15) count
1. Turn the drive roller by hand.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Motors.
1
Does the encoder count change?
No Yes
1
Test the IDO Curler motor (M15)
1. Run M15.
TIPP:
1 2 Does the motor turn?
1 2 No
1 2 3
1340 Kapitel 8 Hardware fault trees
Click Subsystems, click Paper Path, and then click IDO Motors.
Yes
Check the rollers and drive belt
1. Check the bearing, shaft, and rollers on the transport roll assembly.
2. Check the idler rollers.
3. Check the transport drive belt tension.
4. Visually check the drive belts to the rollers.
5. Disconnect the drive belt from the motor and turn the rollers and check for binding or damage.
6. Repair as needed.
„IDO component locator" auf Seite 2365
DEWW