HP CM8060 Color MFP Kundendienst Handbuch Seite 1255

A0.02E2:Tray 1 empty
Initial Steps
1. Verify that the paper-width guide touches the edge of the paper stack.
HINWEIS: Ensure the wiring to the Tray 1 Media sensor (SN27) is not blocking the SN27 actuator. If so install print engine (PE) tag
3.
2. Check the condition of the paper used in Tray 1.
„Tray 1 component locator" auf Seite 2355
Test the Tray 1 Media Edge sensor (SN38)
1. Manually actuate SN38.
TIPP: Click Subsystems, click Input Trays, and then click Tray 1.
Does the sensor state change?
No Yes
Check the following conditions
1. Check the wire harness between the Tray 1 Media Edge sensor (SN38) and the Motion PCA (A2).
„Tray 1 wiring diagram" auf Seite 2259
2. Check the sensor for contamination.
3. Manually actuate SN38.
TIPP: Click Subsystems, click Input Trays, and then click Tray 1.
1 Does the sensor state change?
1 No Yes
1 2 „Final activities" auf Seite 24
Replace the Tray 1 Media Edge sensor (SN38) assembly
1. If the problem persists, replace Tray 1. The ribbon cable and/or the SN38 cable might be damaged.
1 „Sensoren Fach 1" auf Seite 379
Test the voltage to the Tray 1 Media Edge sensor (SN38) on the Motion PCA (A2)
1. Turn off the MFP, disconnect J10 from A2 and connect the Service Test Tool, and then turn on the MFP.
2. Test the voltage to SN38 on A2: 3.21 Vdc at J10 pins 7A to 5A.
„Tray 1 wiring diagram" auf Seite 2259
Is the voltage correct?
No Yes
DEWW A0.02E2:Tray 1 empty 1189