HP CM8060 Color MFP Kundendienst Handbuch Seite 1437

B2.06C4: Left-side Upper Panel LED (LED5) not lit
Initial Steps
1. „IDO component locator" auf Seite 2365
Test the Left-side Upper Panel LED (LED5)
1. Activate LED5.
2. Verify that the LED turns on and off.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the LED turn on and off?
No Yes
Check for problems that might cause intermittent behavior
1. Check the wire harness between the Motion PCA (A2) and the LED.
2. Visually check the LED mounting and surrounding area for any obvious problems. Repair as needed.
1 „IDO H-bar wiring diagram" auf Seite 2287
Check the Left-side Upper Panel LED (LED5) and wire harness
1. Verify that the LED is correctly located.
„IDO H-bar wiring diagram" auf Seite 2287
2. Check the wire harness between the Motion PCA (A2) and the LED.
Test the Left-side Upper Panel LED (LED5)
1. Activate LED5.
2. Verify that the LED turns on and off.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the LED turn on and off?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the Left-side Upper Panel LED (LED5) on the Motion PCA (A2)
1. Disconnect J5 from A2.
2. Test the voltage to LED5 on A2: 2.15 Vdc at J5 pins 17A to 18A.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
No Yes
DEWW B2.06C4: Left-side Upper Panel LED (LED5) not lit 1371