HP CM8060 Color MFP Kundendienst Handbuch Seite 1393

No Yes
Test the voltage at the Transparency sensor 1 (SN1)
1. Verify that J9 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the sensor.
3. Test the voltage at SN1: 0.45 Vdc unblocked and 2.78 Vdc blocked at pins 3A to 2A (GND) and 1.14 Vdc blocked and unblocked
at pins 1A to 2A (GND) on W15P5-W37J5.
„Horizontal component locator" auf Seite 2364
1 Is the voltage correct?
No Yes
1
Replace the Transparency sensor 1 (SN1)
1. Replace SN1.
1 2
„Horizontal wiring diagram" auf Seite 2283
Check the wire harness between the Motion PCA (A2) and the Transparency sensor 1 (SN1)
1. Check the wire harness and connections between A2 and SN1.
„Horizontal component locator" auf Seite 2364
„Horizontal wiring diagram" auf Seite 2283
1 2. Repair as needed.
„D4.0705: Motion PCA (A2) power not good" auf Seite 1469
DEWW B1.1301: Paper jam at Transparency sensor 1 (SN1) 1327