HP CM8060 Color MFP Kundendienst Handbuch Seite 1377

Test the voltage at the Vertical Transport 1 sensor (SN35)
1. Verify that J10 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the sensor.
3. Test the voltage at SN35: 3.3 Vdc at pins 14B to 13B (GND) and 15B to 13B (GND) on W14P6-W36J6.
„Vertical wiring diagram" auf Seite 2301
Is the voltage correct?
No Yes
Replace the Vertical Transport 1 sensor (SN35)
1. Replace SN35.
1 „Vertikalsensoren" auf Seite 390
Test the voltage to the Vertical Transport 1 sensor (SN35) on the Motion PCA (A2)
1. Disconnect J10 from A2.
2. Test the voltage to SN35 on A2: 3.3 Vdc at J10 pins 5B to 6B (GND) and 4B to 6B (GND).
„Motion PCA (A2) diagram" auf Seite 2308
ACHTUNG: Use an ESD strap.
Is the voltage correct?
No Yes
Check the wire harness between the Motion PCA (A2) and the Vertical Transport 1 sensor (SN35)
1. Check the wire harness and connections between A2 and SN35.
„Vertical wiring diagram" auf Seite 2301
„Vertical component locator" auf Seite 2372
1 2. Repair as needed.
„D4.0705: Motion PCA (A2) power not good" auf Seite 1469
DEWW B0.1301: Paper jam at Vertical Transport 1 sensor (SN35) 1311