HP CM8060 Color MFP Kundendienst Handbuch Seite 1421

B2.02E2: Close left-side middle panel
Initial Steps
1. „IDO component locator" auf Seite 2365
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use frame as ground.
Test the Left-side Middle Panel sensor (SN13)
1. Manually activate SN13.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
Fix the door
1. Check the alignment of the left-side middle panel alignment to the Left-side Middle Panel sensor (SN13).
1
2. Check the left-side middle panel hinges.
Check the following conditions
1. Verify that the sensor is correctly located.
2. Clean the sensor and the surrounding area.
3. If the sensor has a flag actuator, check that the flag actuator has free movement.
4. Check the wiring harness between the Left-side Middle Panel sensor (SN13) and the Motion PCA (A2).
„IDO component locator" auf Seite 2365
„IDO paper path 2 wiring diagram" auf Seite 2286
Test the Left-side Middle Panel sensor (SN13)
1. Manually activate SN13.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
1 „Final activities" auf Seite 24
DEWW B2.02E2: Close left-side middle panel 1355