HP CM8060 Color MFP Kundendienst Handbuch Seite 1487

C4.0202: Change web wipe supply
Initial Steps
1. Check the preventive maintenance list for web replacement.
2. If maintenance is due, replace the web material, and then reset the preventive maintenance counters.
Look for a C4.0202 error code
1. Check the Event Log for a C4.0202 error code.
Is a C4.0202 error code displayed?
No Yes
Check the web wipe cartridge and the Web Low sensor (SN21)
1. Reinstall the web wipe cartridge.
2. Clean SN21.
„Web wipe component locator" auf Seite 2373
1 Is the web wipe cartridge correctly installed, and are SN21 and the web wipe cartridge window surfaces clean?
1 No Yes
Test the Web Low sensor (SN21)
1. Unlatch the web cartridge.
HINWEIS:
This sensor is designed to detect a state change at a fixed distance using the web wipe cartridge.
TIPP:
1 2
Does the sensor state change?
1 2 No
1 2 3
Check the wire harness between the Motion PCA (A2) and the Web Low sensor (SN21)
1. Check the wire harness between A2 and SN21.
„Web wipe wiring diagram" auf Seite 2302
„Web wipe component locator" auf Seite 2373
1 2 Is the wire harness in good condition?
1 2 No
DEWW
Using a piece of paper or blocking the sensor by hand will not cause the sensor state to change.
Click Subsystems, and then click Web Wipe.
Yes
Clean and check the Web Low sensor (SN21)
1. Remove the web wipe cartridge.
2. Check for dirt on SN21 and the cartridge window surface.
3. Check the wire harness between the Motion PCA (A2) and SN21.
4. Verify that SN21 is correctly mounted.
Yes
C4.0202: Change web wipe supply 1421