HP CM8060 Color MFP Kundendienst Handbuch Seite 1347

A2.02E3: Close Tray 5 top-left panel
Initial Steps
1. „Tray 5 component locator" auf Seite 2363
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Careful working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use frame as ground.
Test the Tray 5 Top-left Panel sensor (SN112)
1. Manually actuate SN112.
„Tray 5 component locator" auf Seite 2363
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
Test the Tray 5 top-left panel
1. Manually open and close the Tray 5 top-left panel. Look and listen for the latching mechanism to work.
2. Check the alignment between the door actuator and the sensor.
1 Does the Tray 5 top-left panel latch function correctly?
1 No Yes
1 2 „Final activities" auf Seite 24
Check the Tray 5 top-left panel
1. Check the Tray 5 top-left panel latching, sensor actuator, and hinge mechanisms. Verify that they are making contact with the
1 sensor. Replace the Tray 5 top-left panel if necessary.
Check the following
1. Make sure that the sensor is correctly located.
2. Clean the sensor and the surrounding area.
3. Check that any flag actuator has free movement.
4. Check the wire harness between the Tray 5 Top-left Panel sensor (SN112) and the Motion PCA (A2).
„Tray 5 wiring diagram" auf Seite 2281
Test the Tray 5 Top-left Panel sensor (SN112)
1. Manually actuate SN112.
„Tray 5 component locator" auf Seite 2363
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
1 „Final activities" auf Seite 24
DEWW A2.02E3: Close Tray 5 top-left panel 1281