HP CM8060 Color MFP Kundendienst Handbuch Seite 1423

B2.02E3: Close left-side upper panel
Initial Steps
1. „IDO component locator" auf Seite 2365
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use frame as ground.
Test the Left-side Upper Panel switch (SW8)
1. Manually activate SW8.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the switch work?
No Yes
Service the left-side upper panel
1. Check the alignment of the left-side upper panel to the Left-side Upper Panel switch (SW8).
1
2. Check the left-side upper panel hinges.
Check the following conditions
1. Verify that the switch is correctly located.
2. Clean the switch and the surrounding area.
3. If the switch has a flag actuator, check that the flag actuator has free movement.
4. Check the wire harness between the Left-side Upper Panel switch (SW8) and the Motion PCA (A2).
„IDO component locator" auf Seite 2365
Test theLeft-side Upper Panel switch (SW8)
1. Manually activate SW8.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the switch work?
No Yes
1 „Final activities" auf Seite 24
DEWW B2.02E3: Close left-side upper panel 1357