HP CM8060 Color MFP Kundendienst Handbuch Seite 1343

A2.02E1: Reattach Tray 5
Initial Steps
1. „Tray 5 component locator" auf Seite 2363
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Test the Tray 5 Front Latch sensor (SN105)
1. Manually activate SN105.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
Test the Tray 5 Back Latch sensor (SN106)
1. Manually activate SN106.
„Tray 5 component locator" auf Seite 2363
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
1 Does the sensor state change?
1 No Yes
1 2 „Final activities" auf Seite 24
Check the following conditions
1. Make sure that the sensor is correctly located.
2. Check that any flag actuator has free movement.
3. Clean the sensor and the surrounding area.
4. Check the wire harness between the Tray 5 Back Latch sensor (SN106) and the Motion PCA (A2).
1
„Tray 5 component locator" auf Seite 2363
Test the Tray 5 Back Latch sensor (SN106)
1. Manually activate SN106.
„Tray 5 component locator" auf Seite 2363
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
1 Does the sensor state change?
1 No Yes
1 2 „Final activities" auf Seite 24
DEWW A2.02E1: Reattach Tray 5 1277