Stryker InTouch FL27 Wartungshandbuch Seite 34

CONFIGURATION SCREEN (CONTINUED)
D. Bed Options Configuration
Access the configuration screen as shown on
steps below to access the options screen or the serial number screen .
To access the Bed Options screen:
1 . Press and hold the HOB 30 button and the BRAKE button at the same time for 5 seconds then release both buttons .
The message screen shown in Figure 30a will be displayed . Press the Close button .
2 . Once the Close button is pressed in step 1, the Bed Options screen will be displayed as shown in Figure 30b .
Figure 30a: European Community Message
3 . On the Bed Options screen, select all of the options that apply to the bed configuration then press the Continue
button . The 'European Community' option must be selected if you have an InTouch CE bed .
Note: In Figure 30b, the options selected are Zoom, iBed and iAudio, iDoc and European Community.
Options selected will turn green.
4 . After pressing Continue in step 3, a confirmation screen
as shown in Figure 31 will be displayed verifying the
options you selected .
a . If the options on the confirmation screen do not
match the options on the bed, press the Back
button .
b . If the options on the confirmation screen match the
options on the bed, press the OK button .
5 . After pressing the OK button, the options will be saved . A
power cycle screen (Figure 34) will be displayed stating
to cycle power on the bed .
6 . Cycle the power to the bed by first turning the battery
disconnect switch to OFF (O) then unplug the power
cord from the wall outlet . Plug the power cord back
into the wall outlet and then turn the battery disconnect
switch back ON (|) .
7 . Test bed functionality prior to returning the bed into
service .
Return To Table of Contents Return To Table of Contents
1-30
Maintenance Menu Guide
page 1-16 . Once in the configuration screen you will need to follow the
2151-109-006 REV A
Figure 30b: Bed Options Screen
Figure 31: Bed Options Confirmation Screen
www.stryker.com