Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Stryker InTouch FL27 Wartungshandbuch

INTOUCH® CRITICAL CARE BED - (CONTINUED)

Guidance and Manufacturer's declaration - Electromagnetic Emissions

The InTouch® Critical Care Bed is intended for use in an electromagnetic environment specified below . The
customer or the user of the InTouch® Critical Care Bed should ensure that it is used in such an environment .
Emissions Test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic Emissions
IEC 61000-3-2
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
www.stryker.com
EMC Information
Compliance
The InTouch® Critical Care Bed uses RF energy only for
its internal function . Therefore, its RF emissions are very
Group 1
low and are not likely to cause any interference in nearby
electronic equipment .
Class A
The InTouch® Critical Care Bed is suitable for use in all
establishments other than domestic and those directly
Class A
connected to the public low voltage power supply network
that supplies buildings used for domestic purposes .
Complies
2151-109-006 REV A
Electromagnetic Environment
Return To Table of Contents
1-87