Medtronic SYNCHROMED EL serie Gebrauchsanweisung Seite 57

PHM036En2.qxd 2/16/00 12:03 PM Page 48
48 Appendix A: Calculations
3. Program the bolus.
Refer to the Software and Programmer Technical Manual for detailed
programming instructions. Basic programming steps include:
a. Enter the new drug concentration and prescription on the Changes Screen.
b. Program the bolus
at the new drug rate.
c. Verify prescription and bolus dose.
d. Update pump via telemetry.
e. Verify the new prescription on Pump Status after Update Screen.
CAUTION: Performing telemetry to the pump while a bolus is in progress
will terminate and cancel the bolus.
1
Depending upon the calibration constant, some pumps may not accept a single bolus dose larger than
0.52 ml. In the rare case that this should happen, two boluses may need to be programmed in succession.
Call Medtronic for technical assistance.
2
If using a Complex Continuous Mode, remember - you cannot program a bolus. Therefore, when you
want to change the pump drug concentration with this bridging program, you must convert to a Simple
Continuous Mode for one refill cycle and follow the above directions.
Medtronic - Kerkrade / PARTNUMBER :
1 , the bolus duration, and the Simple Continuous Mode
198076-036
2
SHEETNR. :