Programming The Speed Controller; Adjusting The Neutral And Full Throttle Setting - Reely BASH 6S Bedienungsanleitung

10. Programming the speed controller

a) Adjusting the neutral and full throttle setting
If the vehicle does not stay stationary when the throttle/brake lever is in the neutral position, you can adjust the throttle
trim on the remote control. If the trim is insufficient (or if the trim is almost in the end position), you can reset the trim
accordingly.
Proceed as follows:
• Switch on the transmitter, leave the throttle/brake lever
in the neutral position. Set the trim for the drive function
to the neutral position.
• While keeping the setup button (B) pressed, switch on
the speed controller using the slide switch (A) ("ON").
• The red LED on the speed controller will then flash and
the motor will emit beeps. Release the setup button.
If you do not release the setup button, the programming
mode will be enabled in a few seconds, as described in
chapter 10. b). In this case, turn off the speed controller and proceed again as described above.
• Release the throttle/brake lever on the remote control so that it is in the neutral position.
• If you press the setup button (B) briefly, the green LED on the speed controller will flash once briefly and you will
then hear a beep. The neutral position has been saved.
Beeps are generated by a brief activation of the brushless motor. This beep can be very quiet depending
on the motor. If this is the case, note the LED indication on the speed controller.
• Move the throttle/brake lever on the transmitter to the full speed throttle position, then pull it as far as it will go in the
direction of the handle and hold it there.
Warning!
If you do not move the throttle/brake lever on the transmitter or do not move it far enough during
programming, the vehicle may respond to even minute movements of the throttle/brake lever on the
transmitter or become uncontrollable upon completion of programming. In this case, reprogram it.
• If you press the setup button (B) briefly, the green LED on the speed controller will flash twice briefly and you will
then hear two beeps. The full forwards throttle position will be saved.
• Move the throttle/brake lever to full reverse throttle (push the lever away from the handle as far as it will go).
• If you press the setup button (B) briefly, the green LED on the speed controller will briefly flash three times and you
will hear three beeps. The full reverse throttle position will be saved.
• Release the throttle/brake lever to return it to the neutral position. Wait for at least three seconds. The speed
controller will automatically exit settings mode and apply the new settings.
51