Programming The Speed Controller; Programming Of Neutral And Full Throttle Positions - Reely NEW2 Bedienungsanleitung

10. Programming the Speed Controller

a) Programming of Neutral and Full Throttle Positions
If the vehicle does not stop calmly in the neutral position of the throttle/brake lever, you can correct the trimming for
the driving function at the transmitter.
If the trim path is not sufficient (or if the trim is already almost at the end of the trim path) you can reprogram the neutral
position and the full throttle positions for forward/reverse driving.
Proceed as follows:
• Switch on the transmitter, but leave the throttle/brake
in the neutral position. Put the trimming for driving
into the centre position.
• Keep the setup button (B) next to the on/off switch
(A) pressed and turn the speed controller on ("ON").
• The LED flashes at the speed controller then flashes
red; the motor emits bleeps. Release the setup but-
ton again.
If you do not release the setup button, the programming mode is activated after a few seconds (see chapter 10. b).
In this case, switch off the speed controller and proceed again as described above.
• Release the throttle/brake at your transmitter so that it sits in the neutral position.
• Shortly push the setup button (B). The LED at the speed controller flashes green once and a beep is emitted. The
neutral position is now saved.
The beeps are generated by a short start-up of the brushless motor. These beeps may be very low, de-
pending on the motor. In this case, observe the LED on the speed controller.
• Move the throttle/brake lever at the transmitter to full throttle for forwards driving, pull it towards the handle and
hold it there.
Attention!
If you do not move the transmitter throttle/brake lever during the programming process or do not move it
far enough, the vehicle might respond to even slight movements of the transmitter throttle lever or become
uncontrollable. In that case, repeat programming.
• Shortly push the setup button (B). The LED at the speed controller flashes green twice and two beeps are emitted.
The full throttle position for forward driving is stored.
• Move the throttle/brake lever to full throttle for reverse driving, push it away from the handle to the stop.
• Shortly push the setup button (B). The LED at the speed controller flashes green thrice and three beeps are emitted.
The full throttle position for reverse driving is stored.
• Release the throttle/brake so that it sits in the neutral position.
• Now wait for at least 3 seconds. The setting mode is left automatically and the speed controller is ready for opera-
tion with the new settings made.
45