Emc Table; Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Compex sport elite Anweisungen

7. EMC TABLE

The Compex stimulator needs special precautions regarding EMC and needs to be installed and put into service according to the
EMC information provided.
Portable and mobile RF communications equipment can affect the Compex stimulator.
The use of Accessories, transducers, and cables other than those specified by the manufacturer, may result in increased Emissions
or decreased Immunity of the Compex stimulator.
The Compex stimulator should not be used adjacent to or stacked with other equipment and if adjacent or stacked use is necessary,
the Compex stimulator should be observed to verify normal operation in the configuration in which it will be used.
GUIDANCE AND MANUFACTURER'S DECLARATION – ELECTROMAGNETIC EMISSIONS
The Compex stimulator is intended for use in the electromagnetic environment specified below. The customer or the user of the Compex
EMISSION TESTS
Radiated Emissions CISPR 11
Conducted Emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations IEC 61000-3-3
stimulator should assure that it is used in such an environment.
COMPLIANCE
Group 1
Class B
Class A
Complies
19
ELECTROMAGNETIC ENVIRONMENT
– GUIDANCE
The Compex uses RF energy only for
its internal function. Therefore, its RF
emissions are very low and are not likely to
cause any interference in nearby electronic
equipment.
The Compex is suitable for use in all
establishments, including domestic
establishments and those directly
connected to the public low-voltage power
supply network that supplies buildings
used for domestic purposes.
EN