Control RK MultiControl II duo/RK MultiControl II quadro
Activating the safety edge
⇨ The safety edge has been activated.
2.
Select 'Activate safety edge' (Figure 103).
Deactivating the safety edge
⇨ The safety edge has been deactivated.
3.
Select 'Deactivate safety edge' (Figure 104).
If drive group management is activated, this function
only affects drives of the drive group in which it has been
activated.
Therefore, the function has to be activated separately for
every affected drive group.
Figure 103 - Activating the safety edge
Figure 104 - Deactivating the safety edge
The function mode for freeing up the safety edge
(with or without error message) can be set via
⮱
parameter 28
page 270.
251