RK Rose+Krieger Gesamt RK MultiControl II duo Montageanleitung Seite 234

234
Carrying out an initialization run
2.
Press the (
drives is correct.
3.
Press and hold the
the lower final position.
4.
Press and hold the
⇨ The initialization run has been completed. The control unit is ready for
the upper final position.
operation.
) button if the number of connected control units and
If the number is not correct, press the
Figure 70 - Carrying out an initialization run
( ) sbutton until all drives have been moved into
( ) button until all drives have been moved into
If the upper final position cannot be reached or an
upward stroke limitation is to be set, the initialization
run can be ended in any position.
To do so, press and hold the
approximately 5 s. The new position for the upper final
position of the drives has been set.
Control RK MultiControl II duo/RK MultiControl II quadro
( ) button.
button for