Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Control RK MultiControl II duo/RK MultiControl II quadro
2.
If applicable, connect the cable of the second drive (Figure 18/2) to drive
⇨ Connection is complete.
slot M2.
If the extension cable is used for the drives,
reduce the travel speed (parameter 11
For power-intensive drives, e.g. Lambda Colonne (compatible
drives
for one drive.
Only one power-intensive drive per control can be connected.
Drive connections are interconnected via a Y cable
⮱
If power-intensive drives are operated without a Y cable, the
power of these drives can only be used to a limited extent. In
this case, drive slot M1 must be used.
6.4.1.2
Connecting the drives to the RK MultiControl II quadro
Four drives can be connected for each control.
Drives of the same version must be used for all controls
(exception: drive group management
Personnel:
Protective equipment:
◼ The mains cable must be disconnected from the power supply.
Prerequisite:
⮱
page 180), the drive slots M1 and M2 are required
page 178.
◼ Assembly staff
◼ Protective clothing
◼ Safety shoes
⮱
page 180
⮱
page 270).
⮱
page 235).
189
Werbung
