Rs485 Interface (Ptp1); Order Designation; Assembly - Siemens SIMOVERT Master Drives 6SE70 Betriebsanleitung

Options
9.5

RS485 interface (PTP1)

The SST2 serial interface for the basic unit is not available until submodule A2 (C98043-A1690-L1) has been
plugged into the CUR electronics module (A10).
With the parameterization P688=1, the peer-to-peer transmission protocol is implemented on SST2.
The RS485 interface cable required for peer-to-peer coupling to a second unit is described in Section 3.8.7.
9.5.1

Order designation

Three different versions of this module (short designation PTP1, item number C98043-A1690-L1, equipment
identifier A2) can be ordered. The order numbers (MLFB) for these versions are:
1. Module PTP1 with two spacers (1 module)
2. Standard package for 12-pulse mode (2 PTP1 modules with two
spacers for each of two units)
3. Retrofitting package for 12-pulse mode (2 PTP1 modules with two
spacers, 2 CUR control electronics modules and two EPROMs
with up-to-date software for two units)
Versions 1 and 2 require a CUR control electronics module of hardware version 06 or higher (indicated on the
fourth number block of the item number on the module: C98043-A1680-L1-06, C98043-A1680-L1-07, ...) and
software version 3.0 or higher (see the label on the EPROM, fourth number block must be 30 or higher:
V98113-A1800-A001-30, V98113-A1800-A001-31, ... The software version can also be read from parameter
r720.01. The contents must be 3.0 or greater).
9.5.2

Assembly

• Undo the fixing screws
s
removal handles
• Remove the module carefully from the electronics box using the
s
handles .
• Versions 1 and 2: Module PTP1 is a submodule
PTP1 is fitted to the electronics module using the preassembled
spacers. The female rods X115 and X116 must be fitted onto the
corresponding male pins on the CUR.
• Version 3: The PTP1 and EPROM are already fitted to the CUR.
• Slide CUR module (A10) with PTP1 (A2) into the electronics box
carefully along the guide rails as far as the stop.
• Screw the module into position with the fixing screws
below the removal handles
9-6
ENGLISH
a
of the CUR (A10) above and below the
.
s
.
d
of the CUR. The
a
above and
MLFB: 6SE7090-0XX85-1NA0
MLFB: 6SE7090-0XX85-1TA0
MLFB: 6SE7090-0XX85-1TB0
A10
CUR
PMU
X100
X101
X115
X102
X117
X116
X104
Siemens AG 6SE7087-6AK85-0AA0
Common Rectifier Operating Instructions
09.02