Siemens SIMOVERT Master Drives 6SE70 Betriebsanleitung Seite 370

Parameter List
PNU OP1S parameter name
Description
*
: Conf.
Par.
P583 Src 12-Pulse Mode
Source for control command "12-pulse mode is selected" (control word 2, bit
*
23)
0: No 12-pulse mode
1: 12-pulse mode is selected
Other values: see allowed settings in section 4.3.1.1 (process data
B/R parameter
PNU=247Hex; Type=L2; Scaling: 1Hex
P586 Src No ExtFault2
Source of the 'External fault 2' message (control word 2, bit 26)
*
L signal causes disconnection of the faulted unit after a pre-charging time of
+ 200ms if the rectifier/regenerating unit is in the "RUN" status.
0: Not allowed
1: No external fault
1004: Binary input 4 of the CUR board
Other values: see allowed settings in Section 4.3.1.1 (process data
B/R parameter
PNU=24AHex; Type=L2; Scaling: 1Hex
P587 Src Master/Slave
Source for the master/slave drive changeover (control word 2, bit 27)
*
0: Master drive: The control works with an internal current setpoint
1: Slave drive: The control works with an external current setpoint
Other values: see allowed settings in Section 4.3.1.1 (process data
B/R parameter
PNU=24BHex; Type=L2; Scaling: 1Hex
P588 Src No Ext Warn1
Source of the 'External warning 1' message (control word 2, bit 28)
*
0: Not allowed
1: No external warning
Other values:
see allowed settings in Section 4.3.1.1 (process data wiring of
the control word)
B/R- parameter
PNU=24CHex; Type=L2; Scaling: 1Hex
P589 Src No Ext Warn2
Source of the 'external warning 2' message (control word 2, bit 29))
*
0: Not allowed
1: No external warning
Other values: see allowed settings in Section 4.3.1.1 (process data
B/R parameter
PNU=24DHex; Type=L2; Scaling: 1Hex
5-22
ENGLISH
wiring of the control word)
∧ 1
=
wiring of the control word)
∧ 1
=
wiring of the control word)
∧ 1
=
∧ 1
=
wiring of the control word)
∧ 1
=
Value range Display
[phys. unit] Indices
Selection text Factory-
setting
1 to 6005 2
(0)
1 to 6005 2
1
0 to 6005 2
(0)
1 to 6005 2
(1)
1 to 6005 2
1
Siemens AG 6SE7087-6AK85-0AA0
Common Rectifier Operating Instructions
09.02
See
Modify
(access /
status)
3/ BR
3/ BR
2/ BR
2/ BR
2/ BR
2/ BR
3/ BR
3/ BR
3/ BR
3/ BR