Factory Parameters - Siemens SIMOVERT Master Drives 6SE70 Betriebsanleitung

09.02
PNU OP1S parameter name
Description
*
: Conf.
Par.
5.15

Factory parameters

P785 I2t Control Word
Control word for the i
*
0 Response of the i
2
the i
reduction of the limit for the current setpoint to the rated DC
current (in infeed direction or at 92% of the rated direct current
in regenerative feedback direction) until the absolute value of
the current setpoint has dropped below the rated DC current
before its limit (or 92% of that in regenerative feedback
direction) and the calculated equivalent junction temperature
rise is again below the unit-specific response threshold. The
current setpoint limit is then raised again.
1 Response of the i
2
the i
disconnection.
PNU=311Hex; Type=O2; Scaling: 1Hex
P793 Line Voltage Delay
Stabilizing time for the line voltage
If the "Switch-on" command is given, the unit waits in status o 010 for
voltage to be applied to the power section. The line voltage is not assumed
to be applied to the power terminals until amplitude, frequency and phase
symmetry lie within the permissible tolerance range for longer than the time
set with this parameter. The parameter applies to both the rectifier and
regenerative power terminals.
PNU=319Hex; Type=O2; Scaling: 1Hex
P799 Special Access
Parameter for special access
PNU=31FHex; Type=O2; Scaling: 1Hex
Siemens AG 6SE7087-6AK85-0AA0
Common Rectifier Operating Instructions
2
t power section
2
t monitor for the power section (i.e. 100% of
t value has been reached) results in an automatic
2
t monitor for the power section (i.e. 100% of
t value has been reached) results in fault F022 and
∧ 1
=
∧ 0.01 s
=
∧ 1
=
Value range Display
[phys. unit] Indices
Selection text Factory-
setting
0 to 1 -
1
0.01 to 1.00 -
[s] 0.03
0 to 65535 -
0
ENGLISH
Parameter List
See
Modify
(access /
status)
3/ HBR
3/ B
3/ BR
3/ BR
3/U BR
3/ BR
5-37