Siemens SIMOVERT Master Drives 6SE70 Betriebsanleitung Seite 416

Options
Codes:
The last figure in the order code identifies the module location or slot of the electronic box (see below):
1 . . . Board location 2
2 . . . Board location 3
4 . . . Slot D
5 . . . Slot E
6 . . . Slot F
7 . . . Slot G
The following additional modules can be supplied under two order numbers
• under the order number of the board without accessories (such as connectors and Short Guide)
• as a retrofit kit: Board with connectors and Short Guide
Board Order number of board (w/o accessories)
ADB 6SE7090-0XX84-0KA0
CBC 6SE7090-0XX84-0FG0
CBP2 6SE7090-0XX84-0FF5
Slots in the electronics box
Left Slot 1 (CUR)
Center Slot 3 (options)
Right Slots 2 (options)
Only one of each option board type may inserted in the electronics box.
TB (technology boards, e.g. T400) must always be inserted at slot 2.
If only one option board is used it must always be inserted at slot 2.
Small format modules (CBP and CBC) must be plugged in on the adapter board on the right or below (in Slot
E or if a technology module is also used in Slot G).
Use of Slots D and F on adapter boards is not possible because the module plugged in there is not detected
by the basic device.
Table 9.2 Slots for option boards in the electronics box
Local bus adapter (LBA) for mounting optional supplementary boards
Optional supplementary boards can be installed only in conjunction with the LBA option. If an LBA is not already
fitted in the common rectifier, one must be installed in the electronics box to accommodate the optional board.
9-2
ENGLISH
Order number of retrofit kit
6SX7010-0KA00
6SX7010-0FG00
6SX7010-0FF05
Boards
CUR
SCB1 / SCB2 / CBC (with ADB) / CBP2 (with ADB)
CBC (with ADB) / CBP2 (with ADB) / SCB1 / SCB2 / T100 /
T300 / T400
NOTE
Siemens AG 6SE7087-6AK85-0AA0
Common Rectifier Operating Instructions
09.02