Lmt Modes And Services - TR-Electronic CANopen+Multi-Sensor LP-46-K Benutzerhandbuch

CANopen information

3.8.1 LMT Modes and Services

By means of LMT Modes the behavior of a LMT slave is defined. The state behavior is
controlled by LMT COBs produced by the LMT master.
The LMT Modes support the following states:
LMT operation: In this state, all services are supported as defined below
LMT configuration: In this state, all services are supported as defined below
Figure 6: LMT Modes
State behavior of the supported services
Services
Switch mode global
Switch mode selective
Activate bit timing parameters
Configure bit timing parameters
Configure NMT-address
Store configured parameters
Inquire LMT-address
LMT identify remote slave
LMT identify slave
 TR-Electronic GmbH 2010, All Rights Reserved
Page 118 of 183 TR - ELA - BA - DGB - 0016 - 04
Operation Configuration
Yes
Yes
No
No
No
No
No
Yes
Yes
Printed in the Federal Republic of Germany
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
01/20/2017