Setting The Serial Interface (Interface: Com2 (Sim)); Enter Parameter (General) - HBM WTX120 Bedienungsanleitung

Service mode
Com1: End char.
Com1: Checksum
→If start or end character entered and a checksum selected:
Com1: With start
Com1: With end
6.1.3

Setting the serial interface (interface: Com2 (SIM))

Menu
Interface Com2 (SIM2)
6.2

Enter parameter (General)

For more information on the keys required to access this menu group, go to
the Navigation Pilot.
In this menu group you can set various parameters, such as the language, time
zone, date, time, etc.
58
Enter the end character as a decimal value
999
(e.g. 3 = STX)
If you enter 0 no end character will be trans­
ferred
Select checksum formation; the checksum is
None
transferred after the end character:
None No checksum
XOR
CPL
N Start character is included in checksum
formation
N End character is included in checksum
formation
Key Function/secondary selection
A04500_02_Y00_00 HBM: public
Exclusive-Or combination
Complement of twos
WTX120