Editing/Loading From The Usb/Saving To The Usb - HBM WTX120 Bedienungsanleitung

Min. Start w., Crs.fl.off, Crs. Monitor, Fine fl.off, Fine
monitor, Min.Fine fl., Lower tol., Upper tol., Syst.diff.,
Max.dos.t(s), Tare delay(s), Start Fine(s), Crs.mon.(s),
Lockout crs(s), Fine mon.(s), Lock fine(s), Dos.delay1(s),
Dos.delay2(s), Residual(s), Stabilizat.(s), Empt.time(s), Reset
statistic, No.of dosing, Total weight, Mean value, Std.Dev.
Information
The Products group only appears when Application: Filler has been set
in Service Mode/Application/General Setup/Application:Filler .
9.2.1

Editing/loading from the USB/saving to the USB

Before the data can be edited, you must decide whether to edit one of the
existing data sets, upload other data sets from the USB flash drive for editing,
or save the data sets to the USB flash drive.
Menu
Products
1 Edit
WTX120
Key Function/secondary selection
1 Edit
2 Load from USB Load data sets from the
3 save to USB
A04500_02_Y00_00 HBM: public
Supervisor mode
Edit existing data sets
USB stick
Save data sets to USB
flash drive
93