Setting The Serial Interface (Interface: Com1 (Sim)) - HBM WTX120 Bedienungsanleitung

Service mode
→Protocol AckNak selected
Com0: Start char. 999
Com0: End char.
Com0: Checksum
→If start or end character entered and a checksum selected
Com0: With start
Com0: With end
6.1.2

Setting the serial interface (interface: Com1 (SIM))

Menu
Interface Com1 (SIM1)
Com1: Baud:
Com1: Data bits
56
Enter the start character as a decimal value
(e.g. 2 = STX)
If you enter 0 no start character will be trans­
ferred
999 Enter the end character as a decimal value
(e.g. 3 = STX)
If you enter 0 no end character will be trans­
ferred
XOR Select checksum formation; the checksum is
transferred after the end character:
None No checksum
XOR
CPL
N Start character is included in checksum
formation
N End character is included in checksum
formation
Key Function/secondary selection
9600 Select the baud rate of the Com1 interface:
300, 600, 1200, 2400, 4800, 9600,
19200, 38400, 57600, 115200
Select the data format of the Com1 interface:
8
7
8
1 stop bit is always transferred.
A04500_02_Y00_00 HBM: public
Exclusive-Or combination
Complement of twos
7 data bits
8 data bits
WTX120