Connecting The Analog Output (15-Bit) - HBM WTX120 Bedienungsanleitung

Installation
Information
In the event of fluctuations in ground potential, a compensating current may
flow via the double-side shield. In this case an additional equipotential bonding
line must be laid.
4.7

Connecting the analog output (15-bit)

The connection is made at KL4 (also see Tab. 4.3). Device variants with an
optional analog output can be used to indicate gross or net weights via a 15-bit
analog output.
The resolution of the analog output signal is 15 bit (32,768 increments). The
output signal of the analog output is active and potential-free.
The analog output can be optionally balanced to 0/2-10V or 0/4-20mA in
Service Mode group 'DAU15'.
Information
The analog output can be finely adjusted for exact applications.
Notice
Current output 0/4-20mA: The connected load can have a resistance of max.
500 Ohm.
Voltage output 0/2-10V: The connected load must have a resistance of at least
500 Ohm.
28
A04500_02_Y00_00 HBM: public
WTX120