Configuration Of The Fieldbus Interface - HBM WTX120 Bedienungsanleitung

Service mode
→ Perform calibration
AOut 1: 0V =
AOut 1: 10V =
Information
The changed values are overwritten when the mode is changed!
Information
After resetting to the factory defaults, the configuration for the Analog
outputs menu must be performed.
6.4.4

Configuration of the fieldbus interface

Information
Modbus TCP is always provided via the Ethernet LAN interface on the
underside of the WTX120.
66
9 Calibrate zero point, for example =0V,
change analog signal incrementally
4095 Calibrate full load value, for example =10V,
change analog signal incrementally
A04500_02_Y00_00 HBM: public
WTX120