Scheppach HMS1500 Originalbetriebsanleitung Seite 31

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability for
damage to the product or caused by the product arising
from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised spe-
cialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
The operating manual is part of this product.
It includes important instructions for the safe, proper and
economic operation of the product, for avoiding danger,
for minimising repair costs and downtimes and for in-
creasing the reliability and extending the service life of
the product. In addition to the safety instructions in this
operating manual, you must also observe the regula-
tions applicable to the operation of the product in your
country.
Familiarise yourself with all operating and safety instruc-
tions before using the product. Only operate the product
as described and for the specified areas of application.
Keep the operating manual in a good place and hand
over all documents when passing the product on to third
parties.
2. Description of the product
1. Discharge table
1.1 Locking lever
2. Cutter shaft
2.1 Hexagonal bolts
2.2 Pressure bar
2.3 Planer blade
2.4 Grub screws
3. Parallel stop
3.1 Clamping lever for angle adjustment
3.2 Clamping lever for stop width
3.3 Stop holder
3.4 Stop profile
3.5 Coach bolts
3.6 Stop support
3.7 End cap
4. Pick-up table
4.1 Fixing screws
4.2 Left bar
4.3 Clamping sleeves
4.4 Pointer
5. Height adjustment
5.1 Washer
5.2 Locking ring
5.3 Indentation
6. Thicknesser table
7. Suction hood
7.1 Bracket
8. Transport handles
9. Legs
10. Transport wheels
11. On/off switch
12. Belt cover
12.1 Drive belt
12.2 Motor fastening screws
13. Jointer scale
14. Cutter shaft cover
14.1 Cover profile
14.2 Clamping screw
14.3 Clamping lever
14.4 Height adjustment screw
14.5 Holder
14.6 Allen screws
15. Chip ejection cover
15.1 Knurled screw
15.2 Knurled nut
16. Thicknesser scale
17. Crank handle
17.1 Allen screw
18. Push stick
19. Gearing cover
20. Setting gauge
21. Open-ended spanner 8/10 mm
22. Open-ended spanner 10/13 mm
23. Allen key, 3 mm
24. Allen key, 5 mm
25. Allen key, 6 mm
26. Hexagon bolt M6 x 40 mm
www.scheppach.com GB | 31