Special Procedure - SATA AE1031H Bedienungsanleitung

5. Press
tyre will expand, and the beads will seat.
If necessary
6. Continue with inflation to the maximum value of 3.5 bar to
correctly position the tyre on the rim. Avoid distractions during
this procedure, and watch the tyre pressure continuously on the
air pressure gauge (1, Fig. 26d) to prevent overinflation. Inflating
tubeless tyres requires a larger air flow to force the beads past
the HUMP rim.see rim profiles for mounting tubeless tyres in fig
Fig.26e.
7. Check that the beads are correctly inserted in the rim;
otherwise, deflate the tyre, break the beads as described in
the relevant section, lubricate and turn the tyre on the rim.
Repeat the mounting operation described previously and
check again.
8. Replace the internal mechanism of the valve.
9. Adjust the pressure to the rated inflation value by pressing
the deflation button (2, Fig. 26d).
10. Fit the cap to the valve.
5.6.c. SPECIAL PROCEDURE
If the tyre does seat correctly on the wheel during inflation, due to an excessively large gap space between the tyre and
the rim, a jet of pressurised air may be used with the jaw of the optional T.I. accessory (quick bead insertion).
Check that both the upper and lower beads and the rim bead seat have been suitably lubricated with approved paste for
mounting.
1. Clamp the wheel (Fig. 26a).
2. Remove the valve stem core if not already done (Fig. 26b).
3. Connect the inflation hose to the valve stem (Fig. 26c).
4. Pull the tyre up slightly to reduce the space between the upper bead and the wheel rim.
5. Press the inflation pedal and simultaneously press the two buttons on the accessory to deliver a blast of high pressure
air via the four nozzles, which facilitate seating of the tyre beads (Fig. 26f).
AE1031H
to inflate the tyre. The
中文
EN DE RU KO PT JA ES
135